We supply transfer- or engine-attached PTO's for almost any vehicle including medium and heavy trucks and for LandRover / Santana and Toyota as well as crankshaft-driven PTOs! We can offer up to 2 x 230kW of output power.
Boats and ships can be quipped with split-shaft-PTOs mounted inbetween ships' screw driveshaft.

What's a PTO & Pump good for?

• a PTO delivers power straight out of your engine's gearbox. Depending on make and model up to 460kW can be delivered to any machinery flanged onto the PTO driveshaft without any degradation due to falling voltage or ending batteries.
• a PTO can drive heavy winches, hydraulic pumps or compressors at a much higher power than any electrical machinery can.

Types of PTOs

• Gearbox drive: this variant fitx to either the main gearbox (C), the transfer gearbox (D) or inbetween the propshaft (split gearbox PTO - E/F). The PTO is driven via the main gears and can be shifted from 1st to 4th (5th / Reverse) gear. Usually these PTOs are operated when the vehicle is stationary. Nevertheless, driving-synchronous concepts can be adopted, too.
• Crankshaft drive: these PTO are driven by the crankshaft directly without using the gearbox (A, B, C). They can be used stationary and during driving as well. These PTOs bolt either to the bellhousig, to the engine itself or are a system out of the DYNA-pax toolbox.

Please check our general information brochure and catalogue HERE.

On your requests, please always include this information:

• Type of vehicle
• year
• engine
• gearbox type
• transfer type
• axle type

To assist you in rough calcualtions regarding hydraulic system we published an Excel-Spreadsheet.

Delivery as 'made-to-order'.

1 year warranty at non-commercial use.

To be mounted by professionals.

Toyota PTOs for the Heavy-Duty series of LandCruisers

(pic similar)

We offer PTO units for Toyotas as follows:

Toyota LandCruiser PTO Gearbox 8/80 - 01/90

• 18kW max. at 1000 RPM, 30kW max. bei 2000 RPM
• 172Nm max.
• Weight 13kg

L/R-PTO

A PTO fitting the LandRover / Santana and IVECO Massif Tranny LT230-type. This module can engage your PTO by a lever. PTO is pictured top right, mounted with hydraulic pump and tranny (not supplied).

This PTO is the one and only solution to power a good hydraulic winch or other hydraulic equipment. Don't even try to compare it with some half-hearted solutions made out of tuned power steering pumps!

Power ranges up to 76kW. A suitable pump will be offered according to your requirements.

Available from stock!

• air operated PTO clutch - convenient installation!
• Optional mechanical operated clutch
• Gearbox coupled - fits LT230-transfer
• rotation enginewise:38,2kW @ 1000 RPM, axis inline
• rotation anti-enginewise: 30,5kW @ 1000 RPM, ~85mm axis offset, 1.2x transfer ratio
• double bearings per shaft
• flanges ISO 4-bolt and UNI (SAE per request)
• also available driveshaft flange
• max. 2000 RPM, thus doubling output power!

Requires pump, tank, valves and hoses. May require modification of exhaust support. 9-spline gearbox driveshaft required!

We can offer pumps calculated to your requirements.

L/R-CCW-ISO

PTO 38,2kW ISO 4-bolt

888,- EUR net

L/R-CCW-UNI

PTO 38,2kW UNI

995,- EUR net

L/R-CW-ISO

PTO 30,5kW ISO 4-bolt

1220,- EUR net

L/R-CW-UNI

PTO 30,5kW UNI

1322,- EUR net

This is a unique line of Power Take Offs for the IVECO Massif, the successor of the famous Santana PS10, based on the Landrover Defender and the Daily 4x4 as well as the Bremach T-Rex.

These PTOs directly bolt to the main gearbox and are driven via the crankshaft without using the gears themselves. Max. 2400REVS, CCW rotation

Operation works via an electronic panel that engages the PTO and operates a two-way valve.
The electronic control unit provides additional power control and selectable RPM - power compensated throttle.

Available pumps are standard 3-hole hydraulic pumps. 4-bolt-adaptors are available. We can offer pumps selected for your system requirements.

Two different power classes are available:

PTOs and hydraulic system for medium and heavy trucks and utility vehicles.

(similar)

We deliver a wide variety of PTOs - direct, reduced gearing, permanent or engagable, single or dual speed - ehatever...

Ready-to-fit available are also a complete line of hydraulik pumps - please see our information brochure accordingly.

These PTOs will fir the following OEMs of vehicles or gearboxes:

• Aisin
• Allison
• Daihatsu
• Eaton / Fuller
• Ford
• Mack
• Mazda
• Mercedes Benz
• Mitsubishi
• Nissan
• Rockwell
• Scania
• Spicer
• Toyota
• Volvo
• ZF

Please ask us for a suitable offer! Please supply all information on vehicle, year, type of gearbox and transer!

Our DYNA-pax modular system are a configurable set of aggregates, providing an almost unlimited number of variants and combinations regarding pumps, power and energy supply, suitable for all light 4x4, SUV or Pickups.

DYNA-pax is a synthetic term, put together from DYNA for Dynamic and pax short for "Packs".

DYNA-pax are compact compound machines and aggregates such as V-belt driven hydraulic pumps with magnetic cluthes, combined pump-compressor-units and such.

Please check the seperate DYNA-pax section!

DYNA-pax and DYNApax are protected trade mars and©2008 by Power-Trax.de

This compact-sized hydraulic power-pack provides a flexible source of hydraulic energy to any place not accessible to a construction machine or, if your vehicle is not equipped with a hydraulic system

Powered by a 2-cylinder V-type VANGUARD engine, large tanks and high hydraulic power this is a mobile powerpack ease to start with its integrated electrical battery and starter and easily to operate as well.

Technical Data:

• Engine Vanguard 2-cylinder V, 18hp / 13kW
• Hydraulic pump 38l/min, 210bar
• Fuel 16l
• Oil 28l
• 2x2 quick couplings
• electrical starter
• battery 12volts
• weighs 103kg
• grip handles and rubber wheels
• measures only lxwxh 600x500x700mm
• Product Overview (Download) - German version

Built-to-order

5000,- EUR net

DyNS-4x4

This set is the best substitute for a regular PTO we know - unfortunately modern vehicles more and more miss the possibility to mount a regular PTO.
This set enables you to operate a wide variety of hydraulic machinery like motors, gensets, agricultural equipment and winches.

The system consist of:

• Hydraulic pump 45l/min, 200bar
• tooth belt driving system
• Hydraulic tank
• Oil cooler
• control valve

Fits Toyota (HiLux etc.), Nissan, Mitsubishi as well as other vehicles provoding enough room for mounting.

2731,- EUR net.

Built-to-order

DyNS-Quad-PTO

Besides 'classic' O/R vehicles we are able to deliver complete hydraulic sets including PTO and pump for Quads (also known as ATV / all terrain vehicles).
Such an equipment enables you to operate any hydraulic equipment like motors, cylinders, generators and similar!

A detailed brochure can be downloaded HERE.

Such a system consists of:

• Hydraulic pump with mount
• Fluid tank with gauge
• Filter
• Oil Cooler
• manual Control Valve
• hoses and fittings
• Quick Connects

1220,- EUR net.

Models and tech Data

• Honda TRX 300, 8-33l/min, 180bar
• Honda TRX 350, 9-34l/min, 180bar
• Honda TRX 400, 9-50l/min, 210bar
• Suzuki LT 4WD, 8-37l/min, 180bar
• Yamaha YFM 350, 8-33l/min, 180bar
• John Deere, 6-20l/min, 155bar

Special Order, cannot return