With Mobi-Arc Welding Controllers you get mobile Rod- MIG and TIG welding. Ideal addon for vehicles being used as

• Service car
• Towing ute
• Forestry or agricultural utility vehicle
• Sports- or Rallyecar

Mobi-Arc Systems are designed to match the alternator current with models capable of 150A, 200A and 300A. They can be attached to our High-Power Alternators.

Larger Welding Generators can be found in our Hydraulics Section!

Mobi-Arc-Kit 150A

Contains:

• (1) Control Unit
• (1) 6' #4 cable package pre-terminated (1 red, 1 yellow, 1 black)
• (1) 6' 16 gauge wiring harness w/ 10-pin mating connector
• (1) Mounting Bracket, (4) hex-head screws
• (2) Rosette thumb screws w/ (4) nylon washers
• (2) 25mm Dinse welding plugs
• Ground clamp
• Electrode holder (stinger)
• Misc. electrical connectors
• Hand Throttle
• Bypass Kit (electrical tape, directions card, 5/16" bolt)
  
• Manual (English)

Mobi-Arc-Kit 200A

As above, but 200Amps max.

Mobi-Arc-Kit 300A

As above, but 300Amps max.

Voltage Controller & Regulator to use the alternator as fully functional standard alternator replacement for the standard vehicle alternator.

12 (14) Volt or 24 (28) Volt Plug-In Module

Mobi-MIG-Kit with automatic current- and feeder control - fits Mobi-Arc welding systems

Mobi-TIG, a accessory kit to enable your Mobi-Arc of full TIG capabilities (not for Aluminum). Delivery without gas bottle, picture similar

Remote-Control

This module give full and remote control over extended functions provided by the Mobi-Arc Kits 200A and 300A:

• Mode switch Welding / Charging / Jump Start 12V and 24V
• Betriebsarten Schweißen / Laden / externes Schnellladen 12V & 24V
• Batt voltage check
• Weld voltage adjust
• Current meter
• replaces Voltage-Module-Kit